EPSON — Installing the Fabric

Print Workflow Set the Fabric Installing the Fabric 1 Open the rear protective cover. When you open the rear protective cover, the machine decelerates for operation, and the rotary beacon light flashes in orange to notify you. 2 Confirm that the pressure roller is lifted up. If the pressure roller is lowered, turn the selection switch (black) to the left and lift up the roller. 3 Remove the fabric spindle for procedures 3 to 6. Rotate the fabric spindle and align it with the lock release position. Correct position Air inlet is visible Stopper Fabric spindle Incorrect position Air inlet is not visible Fabric spindle 90 WARNING The fabric must be as smooth and firm as possible.

If the fabric edge is fraying and threads are loose, the fiber may come into contact with the head, damaging the head. In the same way, be sufficiently careful to prevent protrusions and fraying at the seam between pieces of fabric. WARNING The machine can operate at a decelerated rate even when the rear protective cover is open. However, use this only in special circumstances. Be particularly careful to avoid your finger being pulled or crushed by the moving pressure roller.