ABB — 3.6. Parameters, стр. 12

FIELDBUS COMMUNICATION 3.6. Parameters Parameter registers begin at protocol address 3000h and consist of one register of one word for each parameter. They are subject to both writing and reading, either a single register or multiple registers at the same request. To write parameters, use Modbus function code 6 Write Single Register or 16 (10h) Preset Multiple Registers. To read parameters, use Modbus function code 3 Read Holding Registers or 4 Read Input Registers. When programming parameters, high bytes shall come before low bytes.

Protocol Address Type Parameter Name Representation Default value 3000h Read/Write Motor rated cur- rent 1 0 – 3700 = 0.0 – 370.0 [A] Individual 3001h Read/Write Start ramp time 1 – 30 [s] 10 3002h Read/Write Stop ramp on 0 = Off, 1 = On 0 3003h Read/Write Stop ramp time 1 – 30 [s] 1 3004h Read/Write Initial voltage 30 – 70 [%] 40 3005h Read/Write End voltage 30 – 70 [%] 30 3006h Read/Write Current limit 15 – 70 = 1.5 – 7.0 [xIe] 70 3007h Read/Write Torque control start 0 = Off, 1 = On 0 3008h Read/Write Torque control stop 0 = Off, 1 = On 0 3009h Read/Write Kick start on 0 = Off, 1 = On 0 300Ah Read/Write Kick start time 1 – 10 = 0.1 – 1.0 [s] 2 300Bh Read/Write Kick start voltage 30 – 100 [%] 50 300Ch Read/Write EOL protection on 0 = Off, 1 = On 1 300Dh Read/Write EOL trip class 0 = 10A, 1 = 10, 2 = 20, 3 = 30 1 300Eh Read/Write EOL protection re- set type 0 = Hand, 1 = Auto 0 300Fh Read/Write Underload protec- tion on 0 = Off, 1 = On 0 3010h Read/Write Underload protec- tion level 2 – 10 = 0.2 – 1.0 [xIe] 5 3011h Read/Write Underload protec- tion reset type 0 = Hand, 1 = Auto 0 3012h Read/Write Locked rotor pro- tection on 0 = Off, 1 = On 0 3013h Read/Write Locked rotor pro- tection level 5 – 70 = 0.5 – 7.0 [xIe] 12 3014h Read/Write Locked rotor pro- tection reset type 0 = Hand, 1 = Auto 0 3015h Read/Write Bad network fault reset type 0 = Hand, 1 = Auto 0 STATUS Approved PAGE 12/22 © Copyright 2019 ABB.