CHASSIS MODIFICATIONS 2-65 E UROCARGO Euro 4/5 Fuel tank When filling the fuel tank is hindered by the position of the body, the tank brackets can be located lower by one jig (45 mm), verifying observance of the minimum height from the ground. If the capacity of the fuel tank is not enough, it is possible to proceed in the following ways: a) Use an original IVECO tank of greater capacity. The following table gives the available types of tanks. Check that the new tank is not incompatible with the original configuration of the vehicle. Table 2.23 - Available tanks b) Addition of a supplementary fuel tank.
The most thorough solution is to fit the additional tank using the same system layout as for the original tank, whenever possible using original elements, particularly the fuel level indicator. A switch can be fitted to allow the two tanks to be used alternatively. Figure 2.27 91471 The use of the above system is advisable when the added tank is located on the side opposite the original one. When the tanks are in line on the same side it is possible to maintain fuel feed from the original tank then the added one should be connected directly to the former through hoses. The arrangement must conform to national rules and regulations.
The tank-to-tank connecting line must be leakproof and not of a smaller internal dimension, have the same technical characteristics as those envisaged for the original system and be properly secured. Electrical system: modifications and drawing-off power Print 603.93.431 Base - January 2008 Vehicle models Fuel tanks 115 l plastic 200 l plastic 280 l aluminium 60E-120EL STANDARD OPT. NO 120E-130E-140E STANDARD OPT. OPT. 150E-160E (E18-E22-E25) STANDARD OPT. OPT. 150E-160E (E28-E30) OPT. STANDARD OPT. 180E-190EL NO STANDARD OPT.