Service Mode The Service Mode should be used only by authorized service personnel. While in Service Mode, you can: G Verify and set the Page Count and serial number. These are displayed on the Configuration Page. G Set the Cold Reset Paper Size Default. (This sets the factory default paper size to either Letter or A4.) G Clear the Event Log. Initiate the Service Mode as follows: 1 Hold down S ELECT and J OB C ANCEL while powering on the printer, until all lights are illuminated and the Display is blank. (If the Display Panel reads INTERNAL TEST at this point, the keys were released too soon. Repeat this step until successful.) 2 Press M ENU , then S ELECT .
The message SERVICE MODE is displayed briefly, then the printer automatically begins an INTERNAL TEST . After several seconds, both Control Panel Indicators turn off. (The printer may display WARMING UP if it has not warmed up completely.) After the printer has warmed up and passed the self test, SERVICE MODE is displayed. 3 Press M ENU once to display SERVICE MENU . To exit the Service Mode press G O . C4085-91087 Service Mode 75