Front and Back Covers Note The procedures for removing the Front and Back Covers are the same. However, before removing the Back Cover, disconnect the Power Supply cable that connects the 8-bin Mailbox Power Supply to the 8- bin Mailbox Controller PCA. WARNING! Unplug the power cord from the 8-bin Mailbox Power Supply, and then unplug the 8-bin Mailbox Power Supply cable from the 8-bin Mailbox Controller PCA. 1 Remove the 8-bin Mailbox from the printer (page 155).
Figure 6-150 8-bin Mailbox Covers (Front and Back) 2 For each cover, using a small flat-blade screwdriver, release the 3 retaining tabs that secure the cover to the right side of the 8-bin Mailbox frame (callout 1), and rotate the cover outward to release it from the frame. To Reinstall: 1 Insert the retaining tabs that secure each cover to the left side of the 8-bin Mailbox frame, and then snap the opposite edge of each cover into position. 332 Chapter 6 Removal and Replacement C4085-91087