fujitsu RX2530 M4 — FUJITSU Server PRIMERGY RX2530 M4

7 Hard disk drive (HDD) / solid state drive (SSD) Safety notes V CAUTION! Before removing several HDD/SSD modules, make sure that all HDD/SSD modules can be reinstalled into their original bay. Otherwise, data may be lost. Do not touch the circuitry on boards or soldered parts. Hold circuit boards by their metallic areas or edges. Before removing an HDD, wait for about 30 seconds until the disk has stopped spinning completely. When an HDD is starting up, a resonant noise may be audible for a short while. This does not indicate a failure. Depending on the operating system, you can configure the write cache settings for the HDDs.

If a power failure should occur while the write cache is enabled, cached data may be lost. When disposing of, transferring, or returning an HDD or SSD, wipe out the data on the drive for your own security. Rough handling of HDDs may damage the stored data. To cope with any unexpected problems, always back up important data. When backing up data to another HDD, you should make backups on a file or partition basis. Be careful not to hit the HDD or bring it into contact with metallic objects. Handle the HDD and SSD on a shock and vibration free surface. Do not use the HDD and SSD in extremely hot or cold locations, or locations with extreme temperature changes.

Never attempt to disassemble the HDD or SSD. For more information, see chapter "Important information" on page 35 . RX2530 M4 Upgrade and Maintenance Manual 129