Hard disk drive (HDD) / solid state drive (SSD) 7.3.5.3 Installing the new 3.5-inch HDD backplane Figure 63: Installing the 3.5-inch HDD backplane К Position the HDD backplane on the three hooks (see circles). К Push the HDD backplane downward. Make sure that the HDD backplane fits into the guides (A). V CAUTION! Ensure that none of the cables are strained or damaged! Figure 64: Connecting the cables to the 3.5-inch HDD backplane К Connect the following cables to the HDD backplane: SAS/SATA data cable:
(1), (2), (4), (5) to connectors "P4", "P3", "P2", "P1" according to the length (6) plug P6 to connector "SGPIO" (3) power cable to connector "X12" I If applicable, connect the OOB cable to connector "SMBus" on the HDD backplane (see figure 61 ). For the cable plan, see chapter "Appendix B" on page 437 . 146 Upgrade and Maintenance Manual RX2530 M4