fujitsu RX2530 M4 — FUJITSU Server PRIMERGY RX2530 M4

Hard disk drive (HDD) / solid state drive (SSD) 7.4.10.3 Installing the new 4x 2.5-inch HDD backplane Figure 82: Installing the 4x 2.5-inch HDD backplane К Position the HDD backplane on the four hooks (see circles). К Push the HDD backplane downward. Make sure that the HDD backplane fits into the guides (A). V CAUTION! Ensure that none of the cables are strained or damaged! К Connect the following cables to the HDD backplane: (1) SAS cable to connector "X5" on the HDD backplane (2) power cable to connector "PWR (X10)" on the HDD backplane I If applicable, connect the OOB cable to connector "SMBus" on the HDD backplane (see figure 81 ).

For the cable plan, see chapter "Appendix B" on page 437 . 7.4.10.4 Concluding steps К Insert all HDD/SSD modules, see section "Installing a 2.5-inch HDD/SSD module" on page 157 . I Make sure that you reinstall the HDD/SSD module in the bay it was located before the HDD backplane replacement. К Insert all dummy modules, see section "Installing a 2.5-inch HDD/SSD dummy module" on page 160 . К "Reassembling" on page 57 К "Connecting the power cord" on page 63 К "Switching on the server" on page 66 170 Upgrade and Maintenance Manual RX2530 M4