fujitsu RX2530 M4 — FUJITSU Server PRIMERGY RX2530 M4

Hard disk drive (HDD) / solid state drive (SSD) Figure 87: Connecting the cables to the ODD and the 4x 2.5-inch HDD backplane К If applicable, push the ODD in its bay until the ODD latch engages (see orange arrow). К Connect the following cables to the ODD and the HDD backplane: (1) power cable to ODD (if applicable) (2) SATA cable to ODD (if applicable) (3) SAS cable to connector "X5" on the HDD backplane (4) power cable to connector "PWR (X10)" on the HDD backplane I If applicable, connect the OOB cable to connector "SMBus" on the HDD backplane (see figure 84 ). For the cable plan, see chapter "Appendix B" on page 437 .

7.4.11.4 Concluding steps К Insert all HDD/SSD modules, see section "Installing a 2.5-inch HDD/SSD module" on page 157 . I Make sure that you reinstall the HDD/SSD module in the bay it was located before the HDD backplane replacement. К Insert all dummy modules, see section "Installing a 2.5-inch HDD/SSD dummy module" on page 160 . К "Reassembling" on page 57 К "Connecting the power cord" on page 63 К "Switching on the server" on page 66 174 Upgrade and Maintenance Manual RX2530 M4