Hard disk drive (HDD) / solid state drive (SSD) PCIe configuration onboard connected only PCIe configuration with 1x Retimer controller in riser module 2 (slot 3) * ) Depending on firmware of iRMC S5 and revision of Combo backplane (see figure 88 and figure 89 ): P2: iRMC S5 firmware FW ≥ 1.25P, backplane revision ≥ D, Chassis-ID custom Infofield0 = R8 P3: backplane revision ≥ C, Chassis-ID custom Infofield0 = RB I Example of connecting OOB cable, see figure 99 (shows P2) and figure 100 (shows P3).
176 Upgrade and Maintenance Manual RX2530 M4 Label color on the color-coded Oculink cable Connector on the system board Connector on the 10x 2.5-inch HDD backplane red PCIe 0 X1A yellow PCIe 1 X2A Connected to system board Connected to 10x 2.5-inch HDD backplane OOB cable plug P1 P2 Label color on the color-coded Oculink cable Connector on the Retimer controller Connector on the 10x 2.5-inch HDD backplane red Port 0 X1A yellow Port 1 X2A green Port 2 X3A black Port 3 X4A Connected to system board Connected to 10x 2.5-inch HDD backplane OOB cable plug P1 P2 or P3 *)