Important information I For a detailed description of how to handle ESD modules, see the relevant European or international standards (EN 61340-5-1, ANSI/ESD S20.20). Transporting the server V CAUTION! Only transport the server in its original packaging or in packaging that protects it from impacts and jolts. In Japan and APAC, transporting the server in its original packaging does not apply. Do not unpack the server until it is at its installation location. If you need to lift or transport the server, ask other people to help you. Never lift or carry the server by the handles or the Quick Release Levers (QRLs) on the front panel. Notes on installing the server in the rack V CAUTION!
For safety reasons, at least 2 people are required to install the server in the rack because of its weight and size. (For Japan, see " 安全上のご注意 ".) Never lift the server into the rack using the QRLs on the front panel. When connecting and disconnecting cables, observe the relevant instructions in the "Important Information" chapter of the technical manual for the corresponding rack. The technical manual is supplied with the corresponding rack. When installing the rack, ensure that the anti-tilt mechanism is correctly fitted. Do not extend more than one server out of the rack simultaneously even if the tilt protection is in place.
If several servers are simultaneously extended from the rack, there is a risk that the rack could tip over. See the safety information of the rack and the warning label. If the server/rack is intended for permanent connection to the mains only an authorized specialist (electrician) is allowed to work. Please follow the regulation of each country. 42 Upgrade and Maintenance Manual RX2530 M4