beckhoff TF5200 — 3 PLC interface

PLC interface 3 PLC interface The PLC interface provides control units to switch channel access to the axes and to display the axes. Jog of path 18 Version: 1.17 TF5200 | TwinCAT 3 CNC Interrupt output of command values to real axes Description This interrupts the output of NC channel command values to physical axes. The NC channel is stopped and assignment to the real axes is disabled. Physical axes can then be requested and moved by another channel. A different logical axis can be linked to a physical axis here. After clearing this interruption, the axes can be requested again and the original channel continues its motion.

Data type MC CONTROL BOOL UNIT, see description of Control unit _ _ _ Access PLC reads request r + state r and writes command w + enable w _ _ _ _ ST path gpCh[channel idx]^.bahn mc control.suspend axis output _ _ _ _ _ Commanded, requested and return values ST element .command w _ .request r _ .state r _ Data type BOOL Value range [TRUE, FALSE] Redirection ST element .enable w _ Position offset Description Display of the current offset of the absolute position between the position controller axis (real physical axis) and the interpolator axis (logical axis) currently linked in the axis coordinate system.

The display here shows an offset between the interpolator position and the position controller position caused by the use of functions such as “jog of path” (see [FCT-C15 [} 8]]. The offset displayed contains no offsets caused by zero offsets, for example. Signal flow CNC → PLC ST path gpAx[axis idx]^.lr state.position offset r _ _ _ _ Data type DINT Unit 0.1 µm Access PLC is reading Axis supply Description The command of the physical axes is executed by the logical axis specified in the NC channel.

Signal flow CNC → PLC ST path gpAx[axis idx]^.lr state.link to ipo r _ _ _ _ _ Data type UINT Value range [= 0 – not linked, > 0 – logical axis number] Access PLC is reading Axis assignment Description The display shows the physical axes to which the commanded values of the logical axes are of the channel output. Signal flow CNC → PLC ST path gpAx[axis idx]^.ipo state.link to lr _ _ _ _