SPECIAL PAINTING, ETC. 2-141 7. BLACK-OUT PAINTING The "black-out" paint is applied on door sashes, rockers, luggage doors, etc. Two types of black-out application (one after the primer-surfacer application and the other after the top coating) are used on assembly lines of new vehicles. During repair, the same process as the original is desired but this some- times causes a problem. When the black-out paint is applied on the rocker prior to the top coat applica- tion, for instance, the under-color will not blend in very easily. Therefore, it is important that you build a repainting process very carefully.
(1) PREPARATION FOR BLACK-OUT PAINTING Primer-surfacer ~ Preparation Black-out ) Masking ) Drying ~ Top coating sanding application ~ Q) Preparation sanding Sand the area on the door sash receiving black-out application (see Page 2-42 for grit informa- tion). ®Masking Mask necessary areas. ® Black-out application on door sashes After air blowing and degreasing, apply the paint in several applications. HINT: · When you use matt black-out paint, test spray it on test pieces to confirm the degree of luster (mix the delustering agent according to the paint manufacturer's instructions). NOTICE: · Paint containing delustering agent must be filtered prior to application (to prevent seeds).
• Paint containing delustering agent must be applied in a very thin coat only. If you apply it thickly, the luster will not fade easily. @Drying Allow a setting time of 10 to 20 minutes, then dry the surface for about 20 minutes at 60°C (140°F) (quick-drying urethane). - 173-