Downloaded from https://www.everyspec.com AMCP 706 210, ATCH -E Ta: C RETURN SPRIN13 ASSEMBL o,- IGN" T CLOCK E SC APEMENT. CONTACTS- .. Figure 11-2. Safing andArmingDevice, GM,-M30Al delay anda self-destruction feature that-willex- the grenade'leaves. the operatr's hand. Thetrig- plode the grenade in 4-5 sec. Since timing a6cu- ger mechanism of hand grenades is similar to that racy is not critical, a pyrotechnic element is-thv of, the firing device shown in Fig. 13-5. The simplest and most widely used-method to achieve M204A2 Hand Grenade Fuze is shown' in- Fig. delay. The explosive train consists of a-percussion '11-4". An example is given, in par., 3.3-4 in which.
primer, an obturated delay element, and a flash the design featuies of the sriker spfingae dis- detontd broblAstiig cap -that wilLdetonate the cussed. grenade. The detonator 'base charge -may be Let us design. a typical haid- grenade fuze omitted in chemical grenades where the main using the firing device and, other standard coin- charge is merely igni!.ed. ponents with a functioning delay of 4 to 5 sec. Since. the grenade's orientation to the target The energy used to initiatethe percussion primer at the time of functioning cannot be,predicted, isderived from the potential energy B, stored in impact action-is difficult to achieve.
by mechan- the spring and released when the striker swings ical means. With an elehtric detonator, an omii- directional switch will solve this-problem. Two = GO =1o kO rdO- (1!5) trembler switches (Fig, 7-1), at right angles to Jo- each-other perform th desired, action; but tiis arrangement is probably too bulky. The M217, where G is the torquethat is proportional to.the Grenade Fuze (Fig. 11-3), for example, has an deflection (= kO),,and r is the radius arm of the all-ways ball switch. Energy -is provided by a striker that swings through 17.radiafs -(1800). thermal~battery having an activation time of 0.5 Since r is 0.5 in. and k is 28/r lWrad sec.
This interval plus that-of a thermal arming switch, closing in 1.5 sec,, provides the arming / -, = -7 u lb-in.= 352. in.-oz .(11-6) delay. A self-destruction switch closes in 4.5 sec. Manual arming of grenade fuzes occurs i;ntwo steps: the operator pulls a safety~pin (pull~ring) If the device is 50% efficient-because of fic. and a safety latch (hand lever),is released when tion, the energy availableas the strikerhits the 11-4