U.S. Army Material Command (AMC) AMCP 706-210 — FUZES - Engineering Design Handbook AMCP 706-210 (U.S. Army) PDF Download

Downloaded from https://www.everyspec.com -AM 6P 706-210- 5 -0 (A) .Free -Position 18() Oderating Posiion Unmounted "Mounted On Rolle Figure 6-6. Negator Spring 6-3.1 AXIALMOTION OF SPRING-DRIVEN SLIDERS dicular to the direction of motion,of a munition may be-drivef, either by springs orby centrifugal Components designed to move. along, the di- forces. 'Usually the sliders are held in their initial rection of motion of a munitionare constrained position'by a lock pin which is removedas part by springs and njoved by indtialforcs. That is, of the arming processand Eq. 6-12 rapplies.

The in an impact device a spring holds the part until situation may easily become that of twc-separate impact occurs; then that part continues its own conditions with the time to act given'by the sum. motion by sliding within'themunition-according of Eqs. 619 and 6-21. to Newton's law on conservation of momentum. Hence, there is relative motion between compo- 6-3.3 TRANSVERSE MOTION OF CENTRIFUGALLY ,nents according~tothe equation DRIVENSLIDERS;. The motion of the slider under centrifugal m" + kx I' - S (6.27) forces isgivenby Eqs. 6-17 and 6-20.

However, if the slider is At an angle-other,,than 900 to tle Under setback or irpact conditions, the fric- spin axis, setback ,and creep forces will also in- tional forces are much smaller thanthe inertial. fluence the motiondirectly. This occurs because 'force I1'a' and may be neglected. the timhe of these forces have acomponent'in, the direction p action may be obtained from Eq. 6-7 whete of motion of the-part. Q= Fig. 6-7 shows the dentrifugally -operated However, ,under drag or ait resistance forces -slider in which -k is the spring force and ;F -is ,where the deceleration is constant, the solution the normal force (reaction) of the restraining to Eq.

6-27 becomes -wall,( F disappears when the slider is not touch- ing the wall). F, is the inertial force equivalent SkS- fa + , (6-28) to the centrifugal force m, r where r is the k ,s radius, of, the center, of mass of the slider from k "cs- kxo is;7 / + f the spin axis., Let a' equal the acceleration of the slider in In this case, xo is measuredin the direction of the direction of the munition spin axis. Then by motion anddenotes the amount of compression assuminga forceF necessary to provide this ac- of the spring. celeration, the forces are resolved in the XV direc- tion (slide motion direction) andthe Y direction.

6.3.2 TRANSVERSE MQIION OF SPRING-DRIVEN Upon combining these two equations, one ob- SLIDERS tains Components designdd to move in a direction -I14'I'i(i.4 n idos,/) - mo(A. (cOs 2 ) - 11cosds I plerpefidicular to or with a component perpen- m M,)2: (cOs - i~si) (6-29)