U.S. Army Material Command (AMC) AMCP 706-210 — FUZES - Engineering Design Handbook AMCP 706-210 (U.S. Army) PDF Download

Downloaded from https://www.everyspec.com AMCP 706'210 Thue shear, stiess -is computefby Eq. 6-32 where 'F is'the-whole load.1'h motion of'the detents-is complicated, if they are allowed. to become skewed; i.e., they 'twist and jam, if the clearance is too large or if the length in the- guide is too short. With -a short rod, large clearance, and sharp corners, friction is:incredised because Athe load is. HINGE confeentrated 'ai~ the bearing areas so that there is PIN a tenden~cy to 'gall or go'uge the'-detent. Fig. 6-9 illustrates this general,,p lrblem. '76-4.2- KNOBS,,LEVERS,"'AND PIVOTS ' ~'Knlobs, are used ,to, select or get fuze function. Normal -knob-d'esign can.

be appliedcbecaUse Ahe (A) Asembfr " F (A) MnmmClearance -Adequate Lengh. 'F/2 2 AREA A '(8) r~ces on Hinge pin, Figure 6.8. Hinge Pin '6-34, the stress caused by bending-is found'to'be Both stresses r and a must beoless than the u'lti- mate strength of the pin'for it to be safe.. Linkages are bulky, 'and~are not used often ()c~'laac dqaeLni because space is'limitedinqfuz~s. Since links-are-, long slendler rneris that, are primiarily adapted to transmitting miotion in one Plane, neiiher they nor their 'joints resist lateral -forces well. They /./ tend to wobble and bifid.

Setback and cenitrifu- gal forces are nearly always at right angles- to each other;,hei 4 ce, linkageg are not desirable in fuzes f6r ug -in spin-stabilized 'projectiles. They are better suited to stationary or 'low velocity //// munitions. Detents ~qre shdrt-rods with a"length -to diam- (C) Excessive Clearance - Short Length eter rativoof 2:1 or,3:1, Their'purpose istore- strict, moO. n by exerting their shear strength. Figure 6-9.- Deteni Actions 6-10