1. Attaching the toe kick panel 2. Aligning the base panel Note: 1. Place base panel on the appliance (do not screw on). Risk of damage to the appliance. Do not cover ventilation openings in the base panel. 2. Measure the difference in depth A between the base panel and the base strip of the adjacent lower cabinets. Nominal dimensions to be observed: 3. Remove the base panel again. 1. Where necessary, cut the base strip to the required length. 4. Adjust the brackets (a) to the dimensions A and tighten. 2. Place base panel on the appliance (do not screw on). 5. Fasten the base panel. 3. Take the protective film off from the adhesive pads on the Velcro strip. 4.
Put the base strip onto the base panel and push firmly. 5. Base strip can be screwed to the base panel from behind. There are holes in the base panel for this purpose. 19