3 Tutorial 4 — Using Measurement Tools in an Inspection Advanced Tool Tutorials 14. Right click Left to Center and select Insert Into. Click the Measurements tab. Double click Tolerance Meas to add it to the Job. Rename Tolerance Meas to Left Pin to Center Distance tolerance. 15. Right click TwoPt Locator and select Insert Into. Click the Measurement tab. Double click Dist2Pts Meas to add it to the Job. Rename Dist2Pts Meas to Right to Center. This will measure the distance between the tip of the right prong and the center of the circle. 16. Right click Right to Center and select Insert Into. Click the Measurements tab. Double click Tolerance Meas to add it to the Job.
Rename Tolerance Meas to Right Pin to Center Distance tolerance. 17. The Job you created should appear similar to the example shown in Figure 3–21. FIGURE 3–21. Using Measurement Tools in an Inspection Job Tree During the setup, will run the currently highlighted tool/step and move on to the next tool/step. A green check mark will appear next to the tool successfully tried when you click this button. Getting Started with Visionscape GigE Cameras 3-31