If there is a failure at this point, the Front Panel will display System Error Code 81:10 . For more information on troubleshooting this error code, refer to page 73. • Calib. Analog Encoder. If there is a failure at this point, the Front Panel will display System Error Code 56:03 . For more information on troubleshooting this error code, refer to page 67. Once the Analog Encoder calibration is completed, the Front Panel will display the results: Acceptable values are: • Gain: between 0 and 5 • DGain between 0 and 15 • Offset: between -80 and 80 If the results are acceptable, press Enter .
If the results are unacceptable, then press the Back / Cancel key and the Front Panel will display System Error Code 56:10 . For more information on troubleshooting this error code, refer to page 67. • Starting media Path. If there is a failure at this point, the Front Panel will display System Error Code 81:10 . For more information on troubleshooting this error code, refer to page 73. • Homing and repeat. test. If there is a failure at this point, the Front Panel will display System Error Code 56:10 . For more information on troubleshooting this error code, refer to page 67. 9. The Printer will now check the Paper Drive PWM.
You must load media in to the Printer and press any key to continue the test. Tests and Utilities 10. When the PWM check is being performed, the following message will be displayed on the Front Panel: • PWM test with paper. 11. Once the PWM check is done, the results will be displayed on the Front Panel. Press any key to finish the test: 104 Chapter 4 Service Tests and Utilities