2. If the Ink Cartridges are not suitable for priming, the following message will appear on the Front Panel. Replace the installed Ink Cartridges with Ink Cartridges that are new or contain less than 88% of ink. Press any key to finish the utility. 3. When the following message appears on the front panel, you must select whether you would like to continue with the procedure by pressing the Enter key, in which case the Printer will reboot. Press Back or Cancel to exit the procedure at this point. 4. Once the Printer has rebooted, the Front Panel will instruct you to open the Window and remove ALL the Printheads installed in the Carriage. 5.
Once ALL the Printheads have been removed, the Front Panel will instruct you to install the Setup Printheads into the Carriage. Make sure you install the Setup Printheads in stalls 1, 3, 5 and 7. Tests and Utilities 6. Once all the Setup Printheads are installed, the following message will appear on the front panel. Close the carriage cover and close the window. 7. The printer will begin to purge the tubes system. 136 Chapter 4 Service Tests and Utilities