3. A message will appear advising you that you will need to load the OMAS Calibration Pattern in to the Printer. Make sure that you rotate the printed pattern 90° clockwise and reload it printed-side down. Press the Enter key to continue. NOTE: Take note that the OMAS Calibration Pattern will be loaded as a Roll and NOT as a Sheet. 4. Load the OMAS Calibration Pattern following the instructions on the Front Panel. LOAD DIRECTION 5. Once the OMAS Calibration Pattern is loaded correctly, the following message will be displayed on the Front Panel. Press the Enter key to continue. Service Calibrations Entering the Service Calibrations Menu 171