10. Insert the T-20 thin bladed torx screwdriver into the access hole at the rear of the printer. 11. Fully tighten the T-20 horizontal attachment screw which secures the OMAS to the printer. Removal & Installation 12. Clip the Media Sensor to the Center Guide. 13. Clip the OMAS access cover back into place by sliding one edge of the cover into the slot and then applying enough pressure to it so you can clip it into the other slot. 14. Calibrate the following: • OMAS ⇒ See page 167 . • Paper Advance Calibration ⇒ See page 157. 1 2 408 Chapter 8 Removal & Installation