Encoder Disc and Sensor Removal WARNING!: Switch off the printer and remove the power cable. CAUTION: Please handle the Encoder Disc very carefully since any finger prints, scratches or stains could cause the Printer to malfunction. 1. Remove the Left Cover ⇒ See page 270 . 2. Remove: • For the 42-inch model, the Left Connector Cover ⇒ See page 287. • For the 60-inch model, the Electronics Module Extension ⇒ See page 288. 3. Remove the Ink Supply Station ⇒ See page 321. 4. Disconnect the Encoder Sensor cable from the PrintMech PCA. Removal & Installation 5. Release the Encoder Sensor cable from the clip located on the Electronics Module. Encoder Disc and Sensor 417