HP — Media Lever Sensor

Media Lever Sensor Removal WARNING!: Switch off the printer and remove the power cable. 1. Remove the Right Cover ⇒ See page 264 . 2. Remove the Right Trim ⇒ See page 267. 3. Remove the Right Connector Cover ⇒ See page 281. 4. Remove the Output Platen ⇒ See page 398. 5. Disconnect the Media Lever Sensor cable from the Interconnect PCA. Removal & Installation 6. Unroute the Media Lever Sensor cable from the cable clamp. 7. Release the Media Lever Sensor Cable from the three clips on the Vacuum Fan. Media Lever Sensor 423