HP — Drive Roller

Drive Roller Removal WARNING!: Switch off the printer and remove the power cable. 1. Remove the Right Cover ⇒ See page 264 . 2. Remove the Left Cover ⇒ See page 270. 3. Remove the Right Connector Cover ⇒ See page 281. 4. Remove: • For the 42-inch model, the Left Connector Cover ⇒ See page 287. • For the 60-inch model, the Electronics Module Extension ⇒ See page 288. 5. Remove the Service Station ⇒ See page 300. 6. Remove the Ink Supply Station ⇒ See page 321. 7. Remove the Media-Axis Motor ⇒ See page 349. Removal & Installation 8. Remove the Encoder Disc and Sensor ⇒ See page 417. 9. Remove the Media Lever Assembly ⇒ See page 420. 10. Remove the Media Sensor ⇒ See page 423. 11.

Remove the Center Guide ⇒ See page 430. 12. Remove two T-10 screws that secure the Drive Roller Gear. 13. Remove the Drive Roller Gear from the Printer. Drive Roller 433