HP — Drive Roller

instructions: 1. Place the Media-Axis Motor Bracket in the correct position on the Printer. Make sure you keep it pushed down (as shown in the illustration) until the first screw has been installed and fully tightened. 2. Install the first screw (T-15) in the position shown. Make sure you tighten the screw fully so that the Media-Axis Motor Bracket cannot be moved. Removal & Installation 3. Check that there is no play (movement) between the Media-Axis Motor Bracket and the Drive Roller. If there is play, then check that the screw installed in the previous step is fully tightened. 4. Install the remaining two screws (T-15) that secure the Media-Axis Motor Bracket.

438 Chapter 8 Removal & Installation