Preventive Maintenance Moisture on the Printer Users should use the Printer in an environment between 20% and 80% relative humidity. To recover from moisture condensation, turn the Printer Off, and, using the main roller as a reference, wait until the Printer is completely dry before using it again. Noisy Carriage Bushing To prevent noisy movement of the carriage, remove aluminum or dust particles from the bushing at the back of the carriage, and from the slider path along which the bushing moves. Belt Swelling To prevent new belts from swelling incorrectly, keep them in their bags with desiccant until you need to install them.
Cleaning the Printer To maintain the Printer in good operating condition, keep it free of dust accumulation, ink, and other contamination. Cleaning intervals are determined by the Printer environment and by the types of Printer supplies used. General Cleaning Proper general cleaning should include the following: WARNING!: To prevent an electric shock, make sure that the Printer is switched OFF and unplugged before any cleaning is performed. Do NOT let any water get inside the Printer. 1. Clean the outer surface of the Printer with a damp sponge or cloth. Use a mild soap and water solu- tion if necessary. Do not use abrasive cleaners. Preventive Maintenance 2.
Wipe the Printer dry with a soft lint-free cloth. Cleaning the Drive Roller and Overdrive CAUTION: If ink is spilled on the Overdrive, remove the ink immediately. Due to the ink's reflectance, ink on the Overdrive can disrupt the Printer's edge-sensing function. To remove any ink from the Overdrive, perform the following procedure. CAUTION: Prevent water or other liquids from running onto electrical components or circuits, or through openings in the Electronics Module. 1. Perform the Turn Drive Roller Utility (Refer to page 134). 2.
Open the window and apply any common household cleaning solution (water based only) to a soft, lint-free rag and apply it to the Drive Roller and Overdrive surface while it is rotating. Make sure that you thoroughly clean the Drive Roller and Overdrive surface. 3. Press Enter when you have completed the cleaning procedure. 4. Allow the Drive Roller to dry before loading media in to the Printer. 452 Chapter 9 Preventive Maintenance