System Error: 21:10 Problem Description: Fault has been detect in the area of the Service Station. Corrective Action: Try the following: System Error Codes • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Make sure that the Service Station path is clear. Remove any visible obstacles (e.g. foam from the printer’s packaging, screws, plastic parts, etc...) restricting the movement of the Service Station. • If the System Error continues, replace the Service Station ⇒ Page 300. System Error: 21:13 Problem Description: Problem with the Service Station. Corrective Action: Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Make sure that the Service Station path is clear. Remove any visible obstacles (e.g. screws, plastic parts, etc...) restricting the movement of the Service Station. • If the System Error continues, replace the Service Station ⇒ Page 300. System Error: 23:10 Problem Description: Problem with pressurization. Corrective Action: Try the following: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer.
• Check that the APS cable is not damaged and is correctly connected to the PrintMech PCA. • Replace the APS Assembly ⇒ Page 324. • R eplace the PrintMech PCA ⇒ Page 384. • If the System Error continues, r eplace the Sausalito PCI PCA ⇒ Page 369. NOTE: Replace one part at a time and check if the error has cleared before replacing another. 52 Chapter 2 System Error Codes