Formatter assembly 2 21 Figure 55. Removing the formatter assembly 1 Print a configuration page and menu map. The information is necessary to reconfigure the printer after you replace the formatter. 2 Remove the rear right side cover (page 138). The formatter assembly is directly underneath. 3 Pull outward on the large metal tab (callout 1) to open the DIMM access door. Remove and transfer any DIMMs or EIO accessories to the new formatter assembly. 4 Remove the two screws (callout 2) to the left of the formatter assembly. 5 Slide the formatter assembly toward the rear of the printer and remove it. Hint If a new formatter assembly is installed, perform a NVRAM initilization (see page 79).
Note Using the configuration page and menu map you printed in step 1 above, reconfigure the printer after replacing the formatter assembly and initializing NVRAM. Be sure to reset the printer’s page count, serial number, maintenance count, all configuration page features, and all control panel settings. Hint When reinstalling the formatter assembly, ensure it is seated over the two stepped screws located behind the formatter assembly. EN Chapter 6 Removing and replacing parts 151