Table 37. Printer messages (continued) Control panel message Explanation Recommended action RAM DISK FILE SYSTEM IS FULL The RAM disk file system is full. 1. Delete unnecessary files and then try again, or turn the printer off, and then turn the printer on to delete all files on the device. (Delete files using HP Resource Manager or another software utility. See the software online help for more information.) 2. If the message persists, increase the size of the RAM disk. Change the RAM disk size from the configuration menu on the printer control panel. HP Resource Manager can also be used to increase or decrease the RAM disk size.
RAM DISK IS WRITE PROTECTED The RAM disk is protected, and no new files can be written to it. Disable the write protection through HP JetAdmin. TONER LOW The message first appears when about 15 percent of the toner is remaining in the toner cartridge (about 1,500 pages remaining for the 10,000-page cartridge and about 900 pages remaining for the 6,000- page cartridge at five percent coverage). Depending on how the printer has been configured in the configuration menu, it will either continue to print or stop. 1. If the printer has stopped, you can resume printing by pressing G O for each job. 2. Advise the customer to have a replacement toner cartridge on hand.
TONER OUT The toner cartridge has run out of toner. Depending on how the printer has been configured, it will either continue to print or stop. Due to the resolution of the toner level sensor, it is possible that a small amount of toner (less than one percent) might still be present in the cartridge. 1. If the printer has stopped, you can resume printing by pressing G O for each job. 2. Replace the toner cartridge. 202 Troubleshooting EN