Table 37. Printer messages (continued) Control panel message Explanation Recommended action 52.X PRINTER ERROR alternates with CYCLE POWER TO CONTINUE The laser scanner speed is incorrect. X description: 1 = Scanner startup error 2 = Scanner rotation error 1. Press G O . The page containing the error will automatically be reprinted. 2. Turn the printer off and then on. 3. Reseat cables to the laser/ scanner and engine controller. 4. Replace the laser/scanner. 53.XY.ZZ PRINTER ERROR There is a memory error with an accessory. The DIMM that caused the error will not be used. Values of X , Y , and ZZ are as follows: X = DIMM type 0 = ROM 1 = RAM 1.
Turn the printer off, and reseat or replace the specified DIMM. 2. Try the DIMM in another slot. (The firmware DIMM must remain in slot #4—the lowest DIMM slot.) 3. Replace the DIMM that caused the error.
Y = Device location 0 = internal memory (ROM or RAM) 1 to 4 = DIMM slots 1, 2, 3, or 4 ZZ = Error number 0, 1, 2 = Unsupported o unrecognized memory 3 = Failed RAM test 4, 5 = Exceeded maximum RAM or ROM size 6 = Invalid DIMM speed 7 = DIMM reporting information incorrectly 8 = DIMM RAM parity error 9 = ROM needs to be mapped to an unsupported address 10 = DIMM address conflict 11 = PDC XROM out of bounds 12 = Unable to make a temporary mapping 54.1 REMOVE SEALING TAPE alternates with FROM TONER CARTRIDGE The toner cartridge has been installed without removing the sealing tape. 1. Open the top cover and remove the toner cartridge. 2. Pull the sealing tape tab to remove the strip. 3.
Reinstall the toner cartridge and close the top cover. EN Chapter 7 Troubleshooting 213