Hantek 6022BE 3.1 Set Oscilloscope Save Setup The oscilloscope software saves the current setup before you close the oscilloscope software. The oscilloscope recalls this setup the next time you run the software. You can use the “ Save Setup ” menu to permanently save up to several different setups. Load Setup The oscilloscope can recall the last setup before the oscilloscope software was running, any saved setups, or the factory setup. You can use the “ Load Setup ” menu to permanently recall a setup. Factory Setup The oscilloscope software is set up for normal operation when it is shipped from the factory. This is the factory setup.
To recall this setup, push the “ Utility -> Default Setup ” menu. 3.2 Set Vertical Systems Click “ Vertical ” in main menu The Vertical Menu function: Turn ON/Off: Turn on/off the channel Volt/DIV: Select the channel voltage/div Invert: Turns the displayed waveform 180 degrees Change Volt/DIV You can click “ Volt/Div ” in “ CH1/CH2 ” Menu to select the voltage You can also change “ CH1/CH2 ” voltage in sidebar User’s Manual 24