7-3. Do-It-Yourself Maintenance ● Prevent the positive and negative terminals from being contacted during the storage, handling and installation of the battery. For example, the metal wrench for connecting the cables can easily touch the positive and negative terminals at the same time, and this may cause short-circuit of the battery, resulting in direct failure. ● Since there is a vent hole on the battery, to prevent leakage, do not place the battery sideways or upside down during storage, handling or installation. ● When replacing the battery, be sure to replace the battery with the same model as the original.
● When replacing the battery, if the terminal clamp becomes oxidized or dirty, be sure to remove the oxidized layer or dirt with sandpaper or the similar, and then apply Vaseline to the clamp and battery terminal before connecting. ● When installing, connect the positive terminal before the negative terminal. When disassembling, remove the negative terminal before the positive terminal to avoid the chance of short circuit. ■ Before charging Pay attention to the following matters before charging: ● If the in-vehicle battery is to be charged, be sure to turn off the engine switch and disconnect the grounding wire.
● Make sure the power switch on the charger is turned off when connecting/ disconnecting the charger cable to/from the battery. ■ When in use ● Prevent the vent hole on the battery from clogging. Take care to clean the vent hole. ● Charge the battery if one of the following conditions occurs: •The vehicle is used often for a short time and started frequently. •The vehicle often travels on traffic congested roads. •There are too many electrical consumers for the vehicle. •The vehicle travels more at night. •The vehicle has not been used for a long time. •The lights stay on after parking. •The doors are not closed fully when parking.
•With the engine shut down, electrical consumers such as A/C, audio system and lights keep operating for a long time. 338