Chapter 2: Installation AC97 AC97 provides high quality onboard audio. The H8DC8/H8DCi features 6-channel (5.1) sound for front L&R, rear L&R, center and subwoofer speakers. This feature is activated with software included on the CD- ROM that came with the serverboard. Sound is output through the Line In, Line Out and MIC jacks (see at right). Activate AC97 with the JPAC jumper (see next section for details) and the BIOS setting for the Audio Codec Line In (blue port): Surround L/R Line Out (green port): Front L/R MIC (pink port): Center/Subwoofer (under South Bridge Confi guration). In addition, there are also CD1 and AUX1 connectors on the board that can be used for audio output.
Audio Output Jumper/ Header The J26 header is used both as a jump- er and a cable header. Jump pins 5-6 and 9-10 to use the backpanel jacks for AC97 audio output (see Figure 2-3). J26 also gives you the option of direct- ing the audio output to Line In/Line Out/ Mic jacks that may be added to the front of the chassis (requires additional hardware, not included). See the table on the right for pin defi nitions. Notes: NC indicates no connection. Pins 6 for front side audio access. Keylock Header and 10 are not active when a header is used The keyboard lock header is designat- ed JK1. Utilizing this header allows you to inhibit any actions made on the keyboard, effectively "locking" it.
2-15 Audio Output Jumper/Header Pin Defi nitions (J26) Pin# Defi nition 1 MIC 2 Ground 3 Reference voltage 4 5V (audio) 5 Line Out (right channel) from board 6 Line Out (right channel) to port 7 NC 8 Key 9 Line Out (left channel) from board 10 Line Out (left channel) to port