Supermicro H8DC8/H8DCi — Supermicro H8DC8/H8DCi Motherboard User & Service Manual PDF

Chapter 2: Installation 3rd Power Supply Fail Signal Enable/Disable The system can notify you in the event of a power supply failure. This feature assumes that three redundant power supply units are installed in the chas- sis. If you only have one or two power supplies installed, you should disable the function with the J3P header to pre- vent false alarms. See the table on the right for jumper settings. I 2 C to PCI Enable/Disable The JI 2 C1/2 pair of jumpers allows you to connect the System Management Bus to any one of the PCI expansion slots. The default setting is closed (on) for both jumpers to enable the connec- tion.

Both connectors must be set the same (JI 2 C1 is for data and JI 2 C2 is for the clock). See the table on right for jumper settings. Audio Enable/Disable Jumper JPAC is used to enable or dis- able the audio. Onboard audio is pro- vided by AC97 audio CODEC for high quality 6-channel (5.1) sound. The de- fault setting is on pins 1-2 to enable the audio. See the table on right for jumper settings.

2-17 3rd Power Supply Fail Signal Jumper Settings (J3P) Jumper Setting Defi nition Open Disabled Closed Enabled I2C to PCI Enable/Disable Jumper Settings (JI2C1/2) Jumper Setting Defi nition Closed Enabled Open Disabled Audio Enable/Disable Jumper Settings (JPAC) Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled