Supermicro H8DC8/H8DCi — Supermicro H8DC8/H8DCi Motherboard User & Service Manual PDF

Chapter 2: Installation SCSI Termination Enable/ Disable (H8DC8 only) Jumpers JPA2 and JPA3 are used to enable or disable termination for the SCSI Channel A and B connector, re- spectively. The default setting is open to enable termination. See the table on right for jumper settings. Note: In order for the SCSI drives to function properly, please do not change the default setting (enabled) set by the manufacturer.) SCSI Controller Enable/ Disable (H8DC8 only) Jumper JPA1 is used to enable or dis- able the onboard SCSI controller. The default setting is on pins 1-2 to enable SCSI. See the table on right for jumper settings.

USB Standby Power Enable/ Disable Jumper J13 is used to enable or dis- able the presence of standby power for all onboard USB ports and headers. Enabling this jumper allows the user to wake-up the system from standby mode with a USB keyboard or mouse. The default setting is on pins 1-2 to dis- able. See the table on right for jumper settings. 2-19 SCSI Term. Enable/Disable Jumper Settings (JPA2, JPA3) Jumper Setting Defi nition Open Enabled Closed Disabled SCSI Enable/Disable Jumper Settings (JPA1) Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled USB Standby Power Enable/Disable Jumper Settings (J13) Jumper Setting Defi nition Pins 1-2 Disabled Pins 2-3 Enabled