Super Micro Computer, Inc. H8DCE-HTe — Super Micro H8DCE-HTe Motherboard User & Service Manual PDF

Chapter 2: Installation Extra USB Headers Four additional USB2.0 headers (USB2/3 and USB4/5) are included on the serverboard. These may be con- nected to provide front side access. A USB cable (not included) is needed for the connection. See the table on the right for pin defi nitions. JLAN1/2 (Ethernet Ports) Two Gigabit Ethernet ports (desig- nated JLAN1 and JLAN2) are located beside the COM2 port. These Ether- net ports accept RJ45 type cables. Fan Headers The H8DCE-HTe has eight fan head- ers, designated FAN1 through FAN8. Fans speed is controlled via Thermal Management with a BIOS setting. See the table on the right for pin defi nitions. Note:

when using active heatsinks (those with fans), connect the heatsink fan for CPU1 to the FAN7 header and the heatsink fan for CPU2 to the FAN8 header. Chipset Fan Headers Two additional fan headers are in- cluded for use with the chipset heat- sinks. Connect the heatsink fan for the nForce Pro 2050 to the "IO4" fan header and connect the heatsink fan for the nForce Pro 2200 to the "CK8- 04" fan header.

2-11 Extra Universal Serial Bus Headers Pin Defi nitions (USB2/3/4/5) Pin # Defi nition Pin # Defi nition 1 +5V 2 +5V 3 PO- 4 PO- 5 PO+ 6 PO+ 7 Ground 8 Ground 9 No connection 10 Key Fan Header Pin Defi nitions (FAN1-8) Pin# Defi nition 1 Ground (Black) 2 +12V (Red) 3 Tachometer 4 PWM Control Chipset Fan Header Pin Defi nitions Pin# Defi nition 1 Ground (Black) 2 +12V (Red) 3 Tachometer