Super Micro Computer, Inc. H8DCE-HTe — Super Micro H8DCE-HTe Motherboard User & Service Manual PDF

Chapter 2: Installation AC97 AC97 provides high quality onboard audio. The H8DCE-HTe features 6-channel (5.1) sound for front L&R, rear L&R, center and subwoofer speakers. This feature is activated with software included on the CD- ROM that came with the serverboard. Sound is output through the Line In, Line Out and MIC jacks (see at right). Activate AC97 with the JPAC jumper (see next section for details) and the BIOS setting for the Audio Codec Line In (blue port): Surround L/R Line Out (green port): Front L/R MIC (pink port): Center/Subwoofer (under South Bridge Confi guration). In addition, there are also CD1 and AUX1 connectors on the board that can be used for audio output.

Audio Header The J26 header is used both as a jumper and a cable connector. Jump pins 5-6 and 9-10 to use the backpanel jacks for AC97 audio output (see Figure 2-3). J26 also gives you the option of directing the audio output to Line In/Line Out/ Mic jacks that may be added to the front of the chassis (requires additional hardware, not in- cluded). See the table on the right for pin defi nitions. Notes: NC indicates no connection. Pins 6 for front side audio access. Power Supply Fail Alarm Reset and 10 are not active when a header is used The system will notify you in the event of a power supply failure (assuming that Supermicro redundant power supply units are installed in the chassis.

Con- nect a microswitch to the JAR header to disable the power supply fail alarm. 2-15 Audio Header Pin Defi nitions (J26) Pin# Defi nition 1 MIC 2 Ground 3 Vcc 4 NC 5 Line Out (Right) 6 Onboard Line Out (Right) 7 NC 8 Key 9 Line Out (Left) 10 Onboard Line Out (Left) PS Fail Alarm Reset Pin Defi nitions (JAR) Pin# Defi nition 2 +5V 1 Ground