H8DCE-HTe User's Manual DMA Mode Selects the DMA Mode. Options are SWDMA0, SWDMA1, SWDMA2, MWDMA0. MDWDMA1, MWDMA2, UDMA0. UDMA1, and UDMA2. (SWDMA=Single Word DMA, MWDMA=Multi Word DMA, UDMA=UltraDMA.) S.M.A.R.T. Self-Monitoring Analysis and Reporting Technology (SMART) can help predict impending drive failures. Select "Auto" to allow BIOS to auto detect hard disk drive support. Select "Disabled" to prevent AMI BIOS from using the S.M.A.R.T. Select "Enabled" to allow AMI BIOS to use the S.M.A.R.T. to support hard drive disk. The options are Disabled, Enabled, and Auto . 32-Bit Data Transfer Select "Enabled" to activate the function of 32-Bit data transfer.
Select "Disabled" to deactivate the function. The options are Enabled and Disabled. SATA Port0/SATA Port1/SATA Port2/SATA Port3 Selecting and hitting the key will open a submenu for SATA Port0 that includes the same items listed for the IDE drives (Type, LBA Mode, Block, PIO Mode, DMA mode, S.M.A.R.T. and 32-bit Data Transfer). Hard Disk Write Protect Select Enabled to enable the function of Hard Disk Write Protect to prevent data from being written to HDD. The options are Enabled or Disabled . IDE Detect Time Out (Sec) This feature allows the user to set the time-out value for detecting ATA, ATA PI devices installed in the system. The options are 0 (sec), 5, 10, 15, 20, 25, 30 and 35 .
ATA(PI) 80Pin Cable Detection This setting allows AMI BIOS to auto-detect the 80-Pin ATA(PI) cable. The options are Host, Device and Host & Device . SATA0 IDE Interface This setting is used to Enable or Disable the serial controller for SATA0. 4-4