F Serial Commands vt [n] Triggers an inspection by pulsing a Virtual I/O point. For example: vt 1 will return pulse VIO1 . The inspection will run if it is configured to use VIO 1 as a trigger. If specified, the VIO index must be in the allowed range for Virtual I/O points within Visionscape. The virtual I/O line will be set high then low. If VIO Index is not specified, VIO1 is assumed. Fail Return: Return !ERROR followed by the reason for the failure. For example: !ERROR No such trigger when the index specified ‘ n ’ is out of range of virtual triggers. WHITEBAL Performs automatic calibration of white balance settings: RED gain, BLUE gain, and GREEN gain. Important:
This command only functions when the camera is OFFLINE. HAWK MV-4000 Smart Camera Guide F-9