Remote Control CN 9 Remote Control The internal resistance tester can be remotely controlled in the following three methods: 1、User-defined programming: The Standard Commands for Programmable Instruments (SCPI) command can be used to control the internal resistance tester. Please refer to HBT4000-SCPI for detailed instructions on commands and programming. 2、 Use IO software: The user can use the IO software to send commands for remote control of the internal resistance tester. PC software IO provided by Keysight is recommended. You can log in to Keysight official website (www.keysight.com) to download the software. operating steps:
⚫ Establish communication between internal resistance tester and computer ⚫ Run IO and search for internal resistance tester resources ⚫ Open the Remote Command Control panel and send the command The internal resistance tester can communicate with PC through the following interfaces： 1 Controlled through USB 2 Controlled through LAN 3 Controlled through RS232/485 The manual will provide detailed instructions on how to use the IO software provided by Keysight to remotely control the internal resistance tester through various interfaces.