Remote control EN 8 Remote control HDG3000C-series signal generators can communicate with computer through the USB interface to achieve remote control. The remote control is implemented based on the SCPI (Standard Commands for Programmable Instruments) command set. Software installation Users can download the application software package of the instrument from the official website of Hantek: http://hantek.com.cn/products/detail/12267 Double click the “ Setup.exe ” file to install according to the installation wizard. Once the installation is complete, the software icon will be displayed on your computer desktop.
Keysight IO libraries suite installation Click on the following URL to download the latest Keysight IO Libraries Suite: http://www.keysight.com/main/software.jspx?Ckey = 2175637 & lc = chi&cc = CN&nid = - 11143.0.00 & id = 2175637 Of course, you can download the package from the official website of Hantek. Double click on the application to start the installation. Follow the installation prompts step by step, and the installation process may take a few minutes. You can see the IO program running in the bottom right corner of the screen after the installation is complete. When the instrument is powered on, connect the instrument to the computer via a USB cable.
The driver will be installed automatically, and you can see the successful installation prompt, as shown in the picture below: After the driver is installed successfully, you can see the driver information in the Computer Management: HDG3000C Quick Guide Copyright © Qingdao Hantek Electronics Co., LTD 16