Harmonic Output EN use the numeric keypad or the direction keys and the knob to input the corresponding value. The range is limited by the maximum output frequency of the instrument as well as the basic waveform frequency. ⚫ Range: integers within 2 to maximum output frequency of the instrument ч basic waveform frequency. ⚫ The maximum value is 16. 7.4 Set the Harmonic Type HDG3000C can output even harmonics, odd harmonics or all orders of harmonics. Press [Wave] > Harmonic softkey on the front panel to enter the harmonic setting menu, and press Type softkey to select the desired harmonic type. 1. Even Select this type and the instrument would output basic waveform and even 2. Odd harmonics.
Select this type and the instrument would output basic waveform and odd harmonics. 3. All Select this type and the instrument would output basic waveform and all the harmonics in order. Note: The harmonics actually output is determined by the "Order" currently specified. 7.5 Set the Harmonic Amplitude Press [Wave] > Harmonic softkey to enter the harmonic setting menu and press Amplitude softkey to set the amplitude of each harmonic. 1. Index: Press this softkey to select the index number of the harmonic to be selected. 2. Amplitude: Press this softkey to set the amplitude of the selected subharmonic.
Use the numeric keypad to input the amplitude value and then select the desired unit from ⚫ For the input method of amplitude value, please refer to the introduction in the pop-up menu, or use the direction keys and knob to modify the current value. "Parameter Setting Method". ⚫ The amplitude units available are Vpp and mVpp. HDG3000C User manual Copyright © Qingdao Hantek Electronics Co., LTD 34