Utility EN output frequencies of all the generators as a same value to realize the synchronization among multi-instruments. 13.3.3 Power On Settings Set the configuration to be used when the instrument is powered on the next time to Default , Last or Output OFF . The default setting is "Default". ⚫ Default : Denote the factory default settings except some parameters (such as: Language). ⚫ Last : Include all the system parameters and output configuration, except clock ⚫ Output OFF : The last setting will be used and all output will be closed. source. Press [Utility] > Startup softkey to select the desired configuration type.
When [P] key is pressed to restore the default settings, this setting will not be affected. 13.3.4 Intensity Press [Utility] > Intensity softkey and use the direction keys and the knob to change the backlight intensity of the screen. The ranges from 1% to 100%. 13.3.5 System Information Press [Utility] > System Info softkey to view the information of the device (such as model, serial number, version number, etc.). 13.3.6 Unit Press [Utility] > Units softkey to select units of waveform parameters. ⚫ Frequency/Period - Select the period or frequency as the waveform parameter that can be set. ⚫ Amplitude/high level - Select the amplitude or high level as the waveform parameter that can be set.
⚫ Offset/Low Level - Select the offset or low level as the waveform parameter that can be set. ⚫ Pulse width/duty cycle - Select the pulse width or duty cycle as the pulse parameters that can be set. Copyright © Qingdao Hantek Electronics Co., LTD HDG3000C User manual 75