3.0 Code Errors Major Codes -88 NOTE: These codes are displayed on the system LCD Display. Code Error Definition/Recommendation 01 Unknown Error No data on what error occurred. Cycle power. 02 PUC Error Path, utilities and controller development library (Used for software testing). Cycle power. 03 No Display Process that runs LCD display generated error. Cycle power. 04 Memory Error Single board computer experienced memory error. Cycle power. 05 LCD Display Failed to write to LCD display board from SBC (error will be seen in .cfg file). 1. Cycle power. 2. Replace LCD Display 06 LCD Keypad Failed to read from LCD keypad to SBC (error will be seen in .cfg file). 1. Cycle power. 2.
Replace LCD Display 07 Manager Channel Socket from manager internal manager process was on, SBC (Software error, will not be displayed). Cycle power. 08 Manager Disconnected Socket from manager internal manager process was off, SBC (Software error, will not be displayed) 09 Manager Send Failed to send from manager (SBC) (Software error) 10 Command Failed Sent legal command that was rejected (exp. Move Z command with door open). Cycle power. 11 Queue Communication Socket from queue process was interrupted (broken) (Software error). Cycle power. 12 Joblog Message Buffer Failed to write to job log (Software error). Cycle power. 13 Joblog File Failed to create the job log (Software error).
Cycle power. 14 Controller Abort Controller failure (See sub errors below) 15 Starting Up Failed Some part of the start up procedure failed. Cycle power. 15.1 Starting Up Failed Verify controller is correctly gendered (gender is the machine type) from the .CFG file. If not, replace with a neutral gender board and perform firmware upgrade. 16 Find Z Failed Failed to find Z limit switch. Check for obstructions or Z switch issues.