HP — Embedded support strands in model

Part Quality Troubleshooting Embedded support strands in model Characteristics: Strands of support material embedded in model. Example of embedded support Problem corrected after re-orientation Corrective actions: 1. Change the part orientation. Rotate part 90 degrees - see example above. 2. Build the part using the “Minimal” support option. 3. Material is built-up on the shields. Using a brush to remove the excess material. 4. Replace tip shields. 5. Check brush flicker assembly for damage or wear. If worn or damaged, replace brush flicker assembly. 6. Tip(s) are loose, check if tip screws are loose. Tighten tip screws. 7. Replace support material. -135