HP — Loss of Extrusion (LOE)

Loss of Extrusion (LOE) Characteristics: Material strands inside build envelope and/or partially built parts. Either the model or support material has failed to extrude from swivel head or toggle plate assembly. Can also be caused by a part falling over or a part shift. Here the support material has had a loss of extrusion, causing the model material to continue to extrude without support material under it. If the model material has had a loss of extrusion, the scenario would be reversed, the support material would have extruded with no model material under it. Corrective actions: NOTE: Also reference Troubleshooting Guide for diagnosing and correcting LOE issues. 1.

Material cartridge is jammed or empty. Replace cartridge. 2. Tips are plugged. Replace the tips 3. Toggle assembly is jammed. Attempt to clear the jam, replace the toggle head assembly if needed 4. Liquefier heater has higher than normal resistance, value should be between 175 and 216 ohms. If resistance is too high, replace the toggle head assembly. 5. Check for twisted or worn filament guide tubes. If worn replace tubes. -137