HP — Material sagging on curved parts

Material sagging on curved parts Characteristics: Surface finish not smooth. Corrective actions: 1. Reprocess the part using the latest version of HP Designjet 3D Software Solution software. 2. Reprocess part with CAD software. 3. Check for bad bearings in X/Y table. Replace XY table if needed. 4. Check Z stage: A. Check Z belt tension. B. Verify Z stage tray is level. C. Verify the Z stage guide rods are not loose. Tighten as needed. D. Check for play on Z lead screw, move up and down. Replace Z stage if needed. -153