HP — Maintenance Preparation

Maintenance Preparation Read these warnings before performing service on printer! WARNING: Make sure the power is disconnected when performing any of the disassembly or assembly instructions in this chapter. Failure to do so can cause severe personal injury or damage to the electronics. WARNING: Servicing instructions outlined in this chapter are intended for use by qualified personnel only. Failure to follow these guidelines can cause severe injury. WARNING: The Power Switch does NOT remove power from the printer. The Breaker Switch located on the rear of the printer MUST be off before service is performed on the printer.

It is recommended that the AC power cord be disconnected before performing maintenance outlined in this chapter. WARNING: Use extreme caution when the door solenoid is disabled. Axes may move unexpectedly, which may cause serious injury. Always remember to enable the door solenoid once service is completed. Note: All references within this procedure to ‘Left’ or ‘Right’ are made assuming that the printer is being viewed from the ‘Front’ (the door and user interface panel side). -159