Figure 71: Disconnecting the J1 connector 5. Remove the display panel. Installing the display panel 1. Connect the J1 Connector. 2. Gently push the display panel into place. 3. Close the display panel access hatch. 4. Close the chamber door. Front Panel Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. Hardware • 10-32 x 1 ⁄ 2 ” slotted screws (x8) Removing the front panel 1. Open the chamber door. 2. Remove the display panel. See “Removing the display panel” on page 165 3. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the 2 mounting screws from behind the display panel. See Figure 72. -166